On this page

A venture debt term sheet is the short, mostly nonbinding document in which a lender sets out the loan it is prepared to make: how much, in how many draws, at what rate, for how long, with which fees, warrants, covenants and security, and on what conditions. Mercury describes it as a nonbinding agreement the lender gives the company; the loan documents that follow are built from it, which is why the term sheet is where most of the deal is won or lost. This page goes through each term, shows an illustrative example term sheet, separates what is negotiable from what usually is not, and works through how to compare two offers. For how venture debt works overall, see the guide to venture debt financing; for what lenders charge today, see venture debt interest rates.

What a venture debt term sheet covers, term by term

Most lenders use their own form, but the headings are close to the same everywhere.

Term What it sets What to check Reference point
Facility size The total the lender commits Whether the company needs all of it Usually 20% to 50% of the previous round (Mercury); 6 to 8 percent of last post-money valuation (First Citizens)
Tranches and draw conditions How much is available at closing and later, and what unlocks each draw Milestones the plan may miss; the date each tranche expires Draw period usually 6 to 12 months, up to 18 (Saratoga)
Interest rate and floor A benchmark, usually prime, plus a spread, with a minimum rate Where the floor sits against today's rate See venture debt interest rates
Interest-only period Months of interest without principal Whether it extends if a milestone is met Typically 12 to 18 months (Mercury); 3 to 18 months or longer at Hercules
Amortization How principal is repaid after interest-only The monthly payment once principal starts Straight-line monthly is common (Mercury)
Maturity When everything is due Fit with the next round or exit Typically 3 to 5 years (Mercury)
Upfront or commitment fee Paid at closing or on the commitment Whether it is deducted from the loan Closing fee of 1% to 2% (Saratoga)
Final or end-of-term payment A lump sum at maturity, also due on early repayment The percentage and what it is a percentage of Quoted as a percentage of the loan (Mercury)
Prepayment fee A charge for repaying early Whether it steps down, and whether it is waived on a refinancing with the same lender (Cooley GO) 3%, 2%, 1% by year in one example (Saratoga)
Unused fee A charge on committed amounts not drawn Whether it applies during the draw period Not every lender charges one
Warrants Right to buy shares, usually at the last round price Coverage percentage, drawn or committed amount, share class, term 3% to 20% of principal at Hercules; warrants often last 10 to 12 years (Mercury)
Covenants and MAC Financial tests, restrictions and the material adverse change clause Definitions, testing dates, cure rights Light or heavy package by lender type (Mercury)
Security and negative pledge Liens on company assets; promises not to pledge them elsewhere Whether intellectual property is in the lien or under a negative pledge (Cooley GO) Usually all assets
Reporting and banking Monthly financials, compliance certificates, account requirements Deadlines and whether accounts must move Monthly reporting is common (Mercury)
Investor support and conditions Investor abandonment clause, diligence, approvals, binding provisions Which sections bind on signing Exclusivity usually 30 to 60 days (Flow Capital)

Ranges are as published by each source; an offer for a given company depends on its stage, investors and loan size.

The covenant package is covered in depth in the guide's section on venture debt covenants. The rest of this page focuses on reading the sheet as a whole.

An illustrative venture debt term sheet

The example below shows how the terms fit together for a hypothetical Series B software company that raised a $20 million round. It follows the order most lenders use.

Term Illustrative example
Borrower A Series B software company (hypothetical)
Facility Senior secured term loan of up to $6,000,000
Tranche A $4,000,000 at closing
Tranche B $2,000,000, available until month 12 if trailing three-month revenue reaches 85% of the board plan
Interest rate Prime plus 2.5%, floating, with a floor of 9.5%
Interest-only period 12 months from closing, extended to 18 months if Tranche B is drawn
Amortization Equal monthly principal payments after the interest-only period
Maturity 42 months from closing
Upfront fee 0.75% of the commitment, $45,000, paid at closing
Final payment 4% of amounts drawn, due at maturity or on prepayment
Prepayment fee 2% in year one, 1% in year two, 0% after
Unused fee None
Warrants Coverage of 3% of amounts drawn, on the Series B preferred at the Series B price, 10-year term
Financial covenant Minimum unrestricted cash of $3,000,000, tested monthly
Material adverse change Event of default, defined by reference to the company's ability to repay
Security All assets except intellectual property; negative pledge on intellectual property
Reporting Monthly financial statements and compliance certificate within 30 days of month end; annual plan within 60 days of year start
Banking Operating accounts at the lender within 60 days of closing
Binding provisions Confidentiality, expenses capped at $40,000, exclusivity of 30 days
Expiry Offer lapses 14 days after issue

Illustrative figures, not client data and not an offer. Prime was 7.00% in November 2026 (Federal Reserve), so the 9.5% floor matches the rate at closing.

The $6 million facility is 30% of the $20 million round, inside Mercury's 20% to 50% range, and 3% coverage on $6 million drawn is $180,000 of warrant stock, inside the 3% to 20% range Hercules reports. The parts worth a second read are the Tranche B condition, which is what makes $2 million of the facility real or not, and the cash covenant, which turns $3 million of the company's cash into money it cannot use.

What is negotiable and what usually is not

The points that most often move:

  • The floor. A floor at today's rate removes any benefit if rates fall.
  • The final payment, in size or in exchange for a slightly higher rate.
  • Warrant coverage, its size and whether it applies only to amounts drawn.
  • The interest-only period, especially with a competing offer. Mercury's own example of a negotiating line is asking a lender to match another lender's 15 months of interest-only.
  • The prepayment schedule, including whether fees are waived on a refinancing with the same lender, which Cooley GO lists among the fee points to raise.
  • Draw conditions and expiry dates on later tranches.
  • Covenant definitions and thresholds, testing dates and a cure period.
  • The intellectual property carve-out, where the lender will accept a negative pledge in place of a lien.

What rarely moves: the lender's security over the company's assets in general, monthly reporting and compliance certificates, the standard events of default, and, at a bank, the requirement to hold operating accounts. Asking for these spends negotiating goodwill that is better used on the points above.

Cooley GO's main advice applies to all of it: get a competing term sheet, because a lender does better when it knows someone else wants the business. Mercury likewise advises collecting at least two. The guide to venture debt lenders covers how to build a shortlist that produces them.

Red flags in a venture debt term sheet

  • A material adverse change clause with no definition, which lets the lender decide when the company is in trouble. Mercury says lenders rarely call one, but the clause still shapes every waiver conversation.
  • An investor abandonment clause tied to vague signals, such as investors "not supporting" the company, with no objective test.
  • Tranche conditions the plan is unlikely to meet, or tranches that expire before the company would need them.
  • Warrant coverage on the full commitment, including money the company may never draw.
  • A final payment and prepayment fee that both apply on a sale, so an exit early in the term carries two charges.
  • Covenants listed without definitions, with "to be agreed in documents" in place of numbers.
  • Binding exclusivity with a deposit, asked for before other offers have arrived.
  • Fees or account requirements missing from the term sheet that the lender says will appear in the loan documents.

Anything left vague in the term sheet is usually settled in the lender's favor in the documents, so it is cheapest to fix before signing.

How to compare two venture debt term sheets

Put each offer into the monthly cash forecast with its draw dates, rate, fees, final payment and amortization, then compare three numbers: the all-in annual cost of the cash, the dilution from the warrants, and the lowest cash balance in a downside case.

A company has two offers for a $5 million loan over 36 months, each fully drawn at closing, with prime at 7.00%. The figures below are in thousands of dollars.

($K) Offer A: bank Offer B: venture debt fund
Rate Prime plus 1.5%, so 8.5% Prime plus 3.5%, so 10.5%
Interest-only months, then amortization 12, then 24 18, then 18
Upfront fee 0.5%, so 25.0 1.0%, so 50.0
Final payment 3%, so 150.0 5%, so 250.0
Monthly payment during interest-only 35.4 43.8
First monthly payment once principal starts 243.8 321.5
Total interest over 36 months 867.7 1,203.1
Total cash cost of borrowing 1,042.7 1,503.1
Annual cost, counting fees and timing (internal rate of return) about 10.5% about 13.5%
Warrant coverage and stock at the last round price 1%, so 50.0 10%, so 500.0
Annual cost if the warrant shares triple by maturity about 11.3% about 20.5%
Covenants and banking Minimum cash and revenue to plan; operating accounts at the bank Monthly reporting only

Illustrative figures, not client data. Spreads and warrant coverage sit inside the ranges Mercury gives for heavy and light covenant loans.

Offer A is cheaper by about $460,000 in cash and far less dilutive. Offer B buys two things: six more months before principal starts, so by month 18 it has repaid nothing while Offer A has repaid $1.25 million, and no financial covenants to breach if revenue falls short of plan. Which is better depends on the downside case. If the company stays comfortably above Offer A's covenants when revenue comes in 20% under plan, Offer A wins. If it does not, Offer B's extra cost is the price of not handing the lender a default. The rates page shows the same calculation for a single offer in more detail, and the venture debt yields tracker shows what public lenders actually earn across their loans, which is a useful check on any all-in figure.

From term sheet to funding: the timeline

Step Typical timing What happens
Term sheets arrive Weeks 3 to 4 of the process Compare side by side in the forecast
Negotiate and sign one About 1 week Exclusivity starts; expenses become payable
Credit approval and confirmatory diligence 1 to 2 weeks Financials, contracts, cap table, investor calls
Loan and security documents 1 to 2 weeks, overlapping Counsel on both sides; definitions settled
Closing and first draw At signing of documents Security filings, account setup, funds
Total from signed term sheet About 3 to 5 weeks

Illustrative timeline for a prepared company, not a lender commitment.

For the full process from first lender calls, see the process and timeline on the lenders page. The most common delay is a forecast that does not tie to the monthly financials, which slows credit approval at every lender. A fractional CFO often builds that forecast, runs the side-by-side comparison and works through the term sheet with counsel before the company signs.

FAQ

Is a venture debt term sheet binding?

Mostly not. The economic terms, such as the amount, rate, fees and warrants, are a nonbinding statement of what the lender intends to offer, subject to credit approval and diligence. Some sections usually are binding, often exclusivity, confidentiality, a deposit and the company's obligation to pay the lender's legal and diligence expenses. Read those before signing, because they apply even if the loan never closes.

How long does it take to go from a venture debt term sheet to funding?

For a prepared company, usually about three to five weeks after signing: credit approval, confirmatory diligence, loan and security documents, and setting up accounts if the lender is a bank. Delays most often come from the company's own records, such as a forecast that does not tie to the monthly financials or a cap table that needs cleaning.

Is there a standard venture debt term sheet template?

No industry-wide template exists the way model equity documents do; each lender uses its own form. The headings are similar across lenders: facility and tranches, interest rate and floor, interest-only period and amortization, maturity, fees, warrants, covenants, security, reporting and conditions. The example on this page follows that order and can be used as a checklist when reading a lender's draft.

How long is exclusivity in a venture debt term sheet?

Flow Capital, a lender, says exclusivity usually runs 30 to 60 days after signing. During that period the company agrees not to negotiate with other lenders. Keep it as short as the closing timeline allows, make sure it ends if the lender changes terms, and sign only once competing offers have been compared.

What should a founder negotiate in a venture debt term sheet?

Usually the floor on the rate, the final payment, warrant coverage and whether it applies only to amounts drawn, the length of the interest-only period, the prepayment fee schedule, draw conditions on later tranches, and the definitions behind any covenant or material adverse change clause. A competing term sheet is the strongest lever in every one of these.

How big a venture debt facility should a term sheet offer?

Mercury puts typical loan size at 20% to 50% of the previous venture round, and First Citizens Bank says venture debt typically hovers between 6 and 8 percent of the last post-money valuation. The right size is the amount the company can repay comfortably in a downside case, which the cash forecast shows before any term sheet arrives.

Want someone looking ahead at your numbers?

Start with a 30-minute call: where things stand, what decisions are coming, and what to fix first.

Book a 30-minute call

Not ready for a call? Take the 2-minute scorecard

Sources

  1. The venture debt term sheet (updated February 3, 2026), Mercury (accessed )
  2. Negotiating the venture debt term sheet (last reviewed July 1, 2024), Cooley GO (Cooley LLP) (accessed )
  3. Demystifying the venture debt term sheet (October 16, 2020), Saratoga Partners (accessed )
  4. How to read a venture debt term sheet, Flow Capital Corp. (accessed )
  5. Hercules Capital, Inc. Quarterly Report on Form 10-Q for the quarter ended September 30, 2026 (filed 2026-10-29), Hercules Capital, Inc. (SEC EDGAR filing) (accessed )
  6. What is venture debt?, First Citizens Bank, Innovation Banking (accessed )
  7. Selected Interest Rates (Daily), H.15, Board of Governors of the Federal Reserve System (accessed )

Educational content, not tax, legal or investment advice. Figures in examples are illustrative, not client data.

Joe Ferretti

, Founder, Decipher

Joe Ferretti founded Decipher, a fractional CFO and FP&A firm. He spent nearly a decade running FP&A inside private equity backed enterprise software companies, building the models investors and buyers use to judge companies.

Joe on LinkedIn